INSTALLING THE ALASKA
STOKER STOVE POWER VENTER
CAUTION: Before installing your Stove and Power
Venter, check all clearancesand local codes. (seepage2)
STEP 1 Remove all parts from Parts Box.
(see List page 3)
STEP 2 Place Stove Body on Hearth. Assemble Stove
Pipe following direction in Stove Manual.
STEP 3 Mark the location for the PowerVent exit hole
by making a light pencil mark around the outside of the
Stove Pipe.
STEP 4 Make the hole one inch larger then the mark
traced on wall. NOTE: When installing power vent be
sure to center the unit in the hole before attaching with
screws
CAUTION: Locate all electricalwires, plumbing lines
and wall studs before cutting any holes.
STEP 5 On the inside wall, locate the center of the hole
you have traced and drill through the outside wall. Locate
drill hole on outside of house. Mark a mark the same size
around as the mark inside of house centered with drill
hole.
STEP 6 Cut out holes
-inside hole first. Followthe
marks.
STEP 7 Locate the Zero Reducer and Power Vent Head.
Insert the crimped end of Zero Reducer into extension of
the Power Venter Head. Fasten with 3 screws.
STEP 8 The PowerVent is made to fit the space
between most inside and outside walls.Test the fit by
putting the PowerVent through the wall hole. If the unit
extends too far into your room, you may want to build
and Extension Box. Once you are satisfiedyou can
proceed to mount as follows:
Apply a bead of silicone around the Mounting Flange of
the PowerVent Unit.
STEP 9 Place PowerVent through wall, centered in
hole, attach with 4 screws.
STEP 10 Connect an extension cord to the PowerVent
Cord and into the wall outlet. Place the Trim Collar over
the Zero Reducer, slide tight to wall, place cord in notch.
Connect stove pipe Zero Reducer with 3 screws.
STEP 11 Locate the Fume Switch Bolt in your Stove
Body (seepage 5). Remove bolt. Remove one of the nuts
from the Fume Switch. Put the Fume Switch Probe into
the hole. Attach probe from inside the stovewith the nut
you removed from the Fume Switch. On StoveModel
140 the bolt is located on the Exhaust Plate.
STEP 12 Locate the Fume Switch. Plug the female end
into Feeder Motor Assemblyand the male end into a 110
Volt wall outlet.
CAUTION: Beforelighting your stove be sure the Power
Venter is running. Always install a Carbon Monoxide
Detector.
4
.
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals